K T - Control Console Time

Home Up Search Credits Site Map Contact Info. Links Disclaimer Download

Control T

Purpose: Use the CONTROL T command to change the time interval or to see the current time interval used for updating dynamic displays on a console.

The UTME parameter on the CONSOLE statement in the CONSOLxx member of SYS1.PARMLIB controls the time interval value at IPL. If the UTME parameter is not coded, the time interval is 30 seconds. 

 K T[UTME=nnn]

[,L=a]

Parameters

T The time interval for updating status displays is to be changed or displayed.

UTME=nnn

The time interval for updating status displays in seconds, where nnn can be any decimal number from 10 to 999.

L=a

Specifies the display area (a) where the display will appear. For cc, you must specify a decimal number from 1 to 99.

If you omit this operand, the display is presented in the first available display area or the message area of the console through which you enter the command (unless routing instructions are in effect; see the MSGRT command later in this chapter).

The information on this site is the combined effort of a lot of people, please credit the authors if you use their information.
Please read the Disclaimer page for the restrictions, copyright, and other uses of the information contained on this site.
For problems or questions regarding this web contact Bob.
Last updated: August 28, 2001.